FIRE SEAL 2000™是一种防油脂防腐蚀的单组分含陶瓷和不锈钢的灰泥，可直接在散热器、排气管或其它高温部件上修缝补洞。彻底干后，它可承受高达2000° F 的高温而且施工时不用停机。 FIRE SEAL 2000™可直接在粗糙的或经过沙磨的钢铁或铸铁表面使用。
使用说明: 用灰泥刀、小毛巾或抹刀施工。固化： FIRE SEAL 2000™ 在16-24小时内干. 固化的最后阶段应一次停机10-15分钟。 FIRE SEAL 2000™ 彻底干后可以使用锉刀或中型砂纸打磨。加工时请不要使用润滑油，但一定要使用防尘面罩以防吸入沙尘。

For years we've been working on a product to repair cracks, pits or holes in exhaust manifolds, tailpipes, mufflers, or other components subjected to high temperatures while in use. Because replacement parts are often difficult or impossible to find, there is a real need for this type of product in the marketplace.FIRE SEAL 2000™ is a single-component (no mixing required) ceramic and stainless steel-filled putty that is resistant to fuels, oils, and corrosives. After it is fully cured, it will withstand temperatures up to 2000° F. FIRE SEAL 2000™ may be applied to rough-surfaced or sandblasted steel, stainless steel, or cast iron.
Instructions: Use a putty knife, small trowel or spatula to apply. Curing: Let FIRE SEAL 2000™ dry for 16-24 hours. Begin final cure by idling engine for 10-15 minutes at a time. You may sand FIRE SEAL 2000™ after it is fully cured, using a file or medium grit sandpaper. Do not use any lubricants for machining, but always use a dust mask to avoid inhaling the sanding dust.

Fire Seal 使用说明[中文][英文]
Fire Seal MSDS (材料安全数据表)[中文][英文]